TVLogic LVM-074W - Manual (Page 8)

8 Multi Format LCD Monitor
3. Controls & Functions
FRONT
• [SDI-A] Button/Lamp
- Used to select SDI-A input.
• [SDI-B] Button/Lamp
- Used to select SDI-B input.
• [HDMI] Button/Lamp
- Used to select HDMI input.
• [ANALOG] Button/Lamp
- Used to select desired Analog input.
(CVB1/2/3, S-Video, Component, RGB)
- Press the button to activate the analog input
menu-selection, then use UP and DOWN
button to select desired input.
* See section “Other Functions [1]ANALOG
Button” for more information.
• [F1][F2][F3][F4] Button/Lamp
- Used to activate the function.
* See section “6.Button Functions -> [4]
Function key set button” for more
information.
• [SCAN] Button/Lamp
- Used to change the scan mode.
- Press the button to activate through the scan
modes: [UNDERSCAN] -> [OVERSCAN] ->
[PIXEL TO PIXEL] -> [USER ASPECT] ->
[UNDERSCAN]
#PIXEL TO PIXEL mode is not available in
graphic mode.
#[USER ASPECT]: User can adjust width and
height of the display.
* See section “7. Other Functions -> [1] Pixel to
Pixel and [2] User Aspect” for more
information.
• [ASPECT] Button/Lamp
- Used to change the display variout ratio.
- Activates in order of [16:9]-[4:3]-[2.35:1]-[1.85:1]
- [15:9]-[16:10]-[AUTO]-[16:9].
• [MARKER] Button/Lamp
- Used to activate/deactivate the Marker. The
type of marker at work may be selected on
the main menu.
• [H/V DELAY] Button/Lamp
- Used to check horizontal sync and vertical
sync simultaneously by moving the display
to the left, right, up and down.
- In this mode, the brightness of image
automatically increase for easy verification of
synchronized signals.
• [BLUE ONLY]/[MONO] Button/Lamp
- Activates in the order of [OFF]-[Blue Only]-
[Mono]-[OFF].
- Press the button to remove red and green
from the input signal and display the screen
only under a blue signal. Press the button
again to activate mono mode.
- They are not available in RGB, DVI ANALOG,
DVI DIGITAL and HDMI modes.
• [MAX BRIGHT] Button/Lamp
- Used to activate the MAX BRIGHT.
• [WAVEFORM]/[VECTOR SCOPE] Button/Lamp
- Pressing the button activate features in the
order of: [O]-[Waveform]-[Vector Scope]-
[Waveform Wide]-[Waveform YCbCr]-[Wave &
Vector]- [Vector_YCbCr]-[Full Waveform(Y)]
-[Full Vectorscope]-[OFF].
- [Waveform YCbCr] : Displays each waveform
for elements of the luminance and Cb/Cr of
the input signal.
- [Wave & Vector] : Displays waveform and
vector scope simultaneously.
- [Vector YCbCr] : Displays Vector scope and Y/
Cb/Cr waveform simultaneously.
* See section “7. Other Functions [3]Waveform
function and [4]Line Select” for more
information.
• [MENU/EXIT] Button/Lamp
- Used to activate the OSD menu.
- When the OSD menu is activated, press this
button to exit from the menu.