TVLogic LVM-074W - Manual (Page 21)

Multi Format LCD Monitor 21
6. Button Functions
2. Use [UP]/[DOWN] Knob to select desired
input source, then enter to confirm.
3. Input signal resolution displays on the
bottom of OSD menu.
4. Press ANALOG button again to remove the
OSD menu from display.
5. Menu will be disappeared when time set is
over from the screen.
* This product is capable of processing all
input signals usable in ANALOG mode.
* The Analog input settings are as follows:
1. Press the ANALOG button on the front of the
product and activate the menu below :
* LVM-074W (SRM-074W) unit is capable of
processing dual SDI Input signal.
1. Press [SDI] button on the front of the
monitor and activate the OSD menu as shown
on the below.
2. Input resolution displays on the bottom of
the OSD screen.
3. Press [SDI] button again to remove the OSD
menu from display.
# If no image displays after selecting the
desired input mode, check and make sure that
your connection is not lose or disconnected.
* LVM-074W (SRM-074W) unit is capable of
processing Single HDMI Input signal.
1. Press [HDMI] button on the front of the
monitor and activate the OSD menu as shown
on the below.
2. Input resolution displays on the bottom of
the OSD screen.
3. Press [HDMI] button again to remove the
OSD menu from display.
# If no image displays after selecting the
desired input mode, check and make sure that
your connection is not lose or disconnected.
[2] SDI Button
[3] HDMI Button
[1] Analog Button