TVLogic LVM-074W - Manual (Page 15)

Multi Format LCD Monitor 15
[4] GPI / UMD
5. Menu Operations
• Momitor ID
- Sets the ID of each monitor for the TV Logic
control protocol or DYNAMIC UMD using RS-
422/485 communication.
- Available values are between 0, 1, 2 ~ 125.
• UMD Display
- This item sets UMD, ANC and DYNAMIC UMD.
* UMD : Displays user customized characters
on screen.
* ANC: Displays characters embedded in SDI
signal.
* DYNAMIC UMD: Displays incoming character
or tally signal from TSL Protocol.
• UMD Character
- Customizes the characters for Under Monitor
Display.
- Alphabets, numbers and special symbols are
available.
- Maximum of 8 characters are available.
• UMD Position
- Used to set position of UMD.
- Activates in order : [Left Top]-[Mid Top]-[Left
Bottom]-[Mid Bottom]-[Left Bottom]-[Left Top].
• XLR TALLY On/Off
- Used to set Tally operation according to
the input level of TALLY IN terminal which is
among the terminals of XLR 4P connector in
the rear.
• XLR TALLY Operating Level
- Used to set the input level of Tally operation.
(Open&Low : less than 0.6V, High : more than
2.5V)
- High: Set the level as “High” to activate the
Tally and set the level as “Low” to inactivate
the Tally.
- Low: Set the level as “Low” to activate the Tally
and set the level as “High” to inactivate the Tally.
• XLR TALLY Color
- Used to set Tally color.
- Available colors are Red and Green.