Toyotomi RCA-2800 - Manual (Page 9)

Wick
height
adjuster
knob
Wick height
adjuster knob
Stem
pin
8
Pull the wick adjuster knob out completely. (It can be removed
completely from its shaft.)
The wick height adjuster knob, with three small holes marked 1, 2,
and 3, can be seen. The stem pin is engaged in one of the holes.
Pull the control dial toward you and change the location of the pin
from 1 to 2, or from 2 to 3. Each step from pin 1 to 2 will raise
the maximum wick height by 2 mm per step. After this adjustment,
replace the wick adjuster knob.
When suitable flame length can no longer be achieved even on pin
position 3, it is time to clean and replace the wick. AFTER
REPLACING THE WICK, CHECK THE OPERATION OF THE
AUTOMATIC EXTINGUISHER BEFORE LIGHTING YOUR HEATER.
NOTE: Never use positions 2 or 3 until position 1 no linger gives
adequate flame length.
EXTINGUISHING THE FLAME
1. Turn the wick adjuster knob counterclockwise until it stops. This
requires about a quarter turn. At this point, the flame is completely
extinguished and the heater is off.
NOTE: DO NOT use the automatic extinguisher to routinely turn off this
heater. Automatic extinguishing should occur only when the
heater is jarred or tipped. Using the automatic extinguisher to
turn off the heater will cause odor, smoke and soot.
2. Make sure the flame is out completely.
3. Do not try to relight the heater for at least three (3) minutes
extinguishing it off as this may cause smoke and odor.
MANUAL SHUTOFF
When quick shutoff is necessary, push the manual shutoff button.
NOTE: For routine turn-off, DO NOT use the Manual Shutoff or activate
the Automatic Extinguisher by jarring the heater. These methods
may cause unwanted odor, soot and smoke. Only the wick
adjuster knob should be used for normal shutoff.
RCA-2800 Type C_US 14.7.10 11:17 ページ 8