beautypg.com

Extinguish, Manual sh, Adjusting the flame – Toyotomi RCA-2800 User Manual

Page 8

background image

Pull the wick adjus
completely from its s

The wick height adju
and 3, can be seen
Pull the control dial
from 1 to 2, or fro
the maximum wick
replace the wick adj

When suitable flame
position 3, it is
REPLACING THE
AUTOMATIC EXTING

NOTE: Never use po
adequate flame leng

EXTINGUISH

1. Turn the wick adju

requires about a qu
extinguished and th

NOTE: DO NOT use th

heater. Automa
heater is jarred
turn off the hea

2. Make sure the flame

3. Do not try to reli

extinguishing it off a

MANUAL SH

When quick shutoff is n

NOTE: For routine turn

the Automatic E
may cause un
adjuster knob s

Maximum

Correct

Minimum

Correct

Too low

Produces odor

GOOD

Too high

Produces smoke

and soot

BAD

GOOD

BAD

NOTE: An improperly seated heat chamber can cause high flame,

smoke, and potential damage to the heater itself. Do not leave
the heater until you have determined that the flame is burning
normally, will be described in the following section.

ADJUSTING THE FLAME

1. After lighting wait for the heat chamber to reach operating temperature. This will take several

minutes, then the flame will be visible.

2. CHECK THE FLAME HEIGHT

After five minutes, the entire heat chamber should be glowing red.

If necessary, raise or lower the wick by turning the wick adjuster knob to produce the proper flame
condition.

NOTE: Do not operate your heater wick set TOO LOW or TOO HIGH. Doing so will decrease

combustion efficiency and increase production of unwanted emissions. When operating
heater, be sure wick is high enough to keep the primary heat chamber heated to a uniform
red glow from its top to bottom.

3. ADJUSTMENT OF MAXIMUM WICK HEIGHT

After using the heater over a long period of time, you may observe that the flame length in heat
chamber does not reach its normal level in several minutes after lighting. When this condition is
observed, it means that the wick height needs adjusting the unique wick life extender.

To adjust the wick height using the wick life extender mechanism,
first release the automatic extinguisher by pushing the manual
shutoff button.

7

RCA-2800 Type C_US 14.7.10 11:17 ページ 7