Check befo, Lighting – Toyotomi RCA-2800 User Manual
Page 6

CHECK BEFO
1. LEVEL THE HEATER
The heater should b
NOTE: If your heate
Do not prop
2. ENGAGE THE AUTO
The automatic extin
wick adjuster knob c
NOTE: When it is dif
counterclockw
LIGHTING
NOTE: When you first
garage or an a
remove all of t
done inside, so
THE FIRST TIM
NOTE: If you have fuel
fuel for a long t
saturated.
1. Turn the wick adjust
As the wick rises wi
some resistance and
the wick has reache
fully engages.
The wick adjuster k
the flame.
2. AUTOMATIC LIGHTI
Gently push the igni
the wick.
NOTE: If you have diff
very slightly to
the wick.
3. LIGHTING WITH MA
You should not have
become necessary, o
the wire handle and t
burned parts of the m
NOTE: To restore the
replace worn
replace it.
4. Be sure that heat c
handle left and right
that the heat chamb
Stop
here
Fuel Gauge
Manual shutoff button
Igniter button
Wick adjuster knob
Removable fuel tank
Top plate
Grille
Body
Heat
chamber
Tank lid
Drip tray
Fuel indicator
Front panel
1. Open the fuel tank lid on the top of heater cabinet and lift out the
removable fuel tank. Turn the removable tank upside down and remove
the fuel tank cap.
2. Insert the straight tube of the manual siphon into the kerosene (paraffin)
container. Insert the siphon’s flexible hose into the removable fuel tank
opening.
3. Turn the air vent knob on the top of the siphon clockwise to close the
vent. Start the flow of kerosene (paraffin) by squeezing the bulb of the
siphon vigorously six or seven times. Once flow begins, it is no longer
necessary to squeeze the bulb.
4. Watch the fuel gauge on the removable tank to avoid overfilling.
When it shows half, stop flow by turning the air vent knob
counterclockwise.
NOTE: Be careful to avoid overfilling the tank, especially with very cold
kerosene (paraffin). Overflow might occur due to expansion
when the fuel warms up.
5. Remove the siphon carefully, allowing excess kerosene (paraffin) to drain from the tube back into the
container. replace fuel tank cap and tighten it securely. Be sure to wipe away any spilled kerosene
(paraffin) from tank and other heater parts.
6. After making sure fuel tank cap is tightly fastened, invert tank and replace into heater body.
5
RCA-2800 Type C_US 14.7.10 11:17 ページ 5