Toyotomi RCA-2800 - Manual (Page 5)

ASSEMBLY AND OPERATION
INSPECTION AND ASSEMBLY
NOTE: Please save the shipping carton packing materials for future storage of your heater.
1. REMOVE PACKING MATERIALS
Open the grille by raising the lower right hand corner of grille and pulling straight out. Remove the
styrofoam packing wedge from under the top plate of cabinet to release the heat chamber
assembly. Lift the heat chamber, in its protective packing, out of the cabinet.
2. REPLACE THE HEAT CHAMBER
Remove the cardboard packing, and replace the heat chamber assembly. Point the wire handle to
the front of the heater.
Close the grille.
3. INSTALL THE BATTERIES
Locate the battery holder on the back of your heater.
¡ Insert the battery 2 “D” size batteries according to the plus (+) and
minus (–) markings.
4. CHECK THE HEAT CHAMBER
If the chamber is raised, put it down and inlay it.
NOTE: If the heat chamber is raised, it can cause smoke and soot.
FUELING
WARNING: Use only clean kerosene (paraffin).
Never use gasoline (petrol) or other flammable liquids.
4
RCA-2800 Type C_US 14.7.10 11:17 ページ 4