Toyotomi RCA-2800 User Manual
Page 11
7. Remove the screw on the stem holding the bracket and
remove the bracket, spring and wick height adjuster
knob.
8. Turn the stem clockwise until it stops and remove the
wick sleeve with wick.
9. Turn the wick sleeve counterclockwise and lift the wick
sleeve with wick up.
Remove it from the primary air tube.
10. Squeeze the wick to loosen the three pins and remove
the wick from the wick sleeve.
11. Install the wick to the wick sleeve according to the
allowed direction engraved on the wick sleeve.
12. Install the wick sleeve with wick to the primary air
tube. And then turn the wick sleeve clockwise to set
the handle arm.
13. Install the wick height adjuster knob, spring and
bracket. The wick position should be adjusted at
No.1. Then tighten the screw which is holding the
stem.
14. Put the wick adjuster back into position.
10
RCA-2800 Type C_US 14.7.10 11:17 ページ 10