Tempest Twister - Manual (Page 7)

Twister Enclosure User Manual page 7
2.5 Air inlet and Exhaust Cowls
Twister enclosures are supplied with two plastic cowls and filters for the air inlet and exhaust vents. Use of the
cowls differs according to the orientation of the enclosures
2.5.1 Base-Up Installation
Insert the two filters into the cowl
slots.
Insert two rain guards between the
plastic cowl and the Twister base as
shown
Mount the cowls and rain guards onto
the Twister base plate, using the
screws provided
2.5.2 Base-Down Installation
Insert filters and mount as shown.
Using a sharp box-cutter knife, remove the outer chambers of the inlet and exhaust cowls.
2.5.3 Horizontal Installation
First, trim the outer chambers of the inlet
and exhaust cowls, using a sharp knife, as
described above for base-down installation.
Mount both cowls onto the Twister base plate, with the filter
end facing DOWN, as shown.
Rain guard Rain guard location