Signamax 10/100BaseT/TX Ethernet Extender Media Converter - Manual (Page 10)

Industrial Ethernet Extender
10
Installation
This chapter gives step-by-step installation instructions for the Ethernet
Extender.
Selecting a Site for the Equipment
As with any electric device, you should place the equipment where it will not
be subjected to extreme temperatures, humidity, or electromagnetic
interference. Specifically, the site you select should meet the following
requirements:
The ambient temperature should be between -20 to 60 degrees Celsius.
The relative humidity should be less than 90 percent, non-condensing.
Surrounding electrical devices should not exceed the electromagnetic
field (RFC) standards.
Make sure that the equipment receives adequate ventilation. Do not
block the ventilation holes on each side of the equipment.
The power outlet should be within 1.8 meters of the product.
Connecting to Power
This Ethernet Extender is a plug-and-play device.
Connect the supplied AC to DC power adaptor to the receptacle on the
rear panel of the Ethernet Extender, and then attach the plug into a
standard AC outlet with a voltage range from 100 to 240VAC.