Important notes – Paxton Superchargers Mustang Air/Air Cooler User Manual

Page 4

P/N: 4809638

10NOV03 v2.0 99-01 MusGT(4809638 v2.0)

IMPORTANT NOTES

ongratulations! You have purchased the
finest street charge cooler available for
the Mustang GT. The centerpiece of this

kit is the Highly Efficiency PAXTON charge
cooler.

This kit comes with all the parts you will need to
install the charge cooler. The instruction manual
has been edited in order of sequence, and photo-
graphs and drawings have been included to illus-
trate the text. This will allow you quick part
identification and orientation.

The installation will require metric and SAE
sockets and wrenches, a hand drill and bits.

Become familiar with the details of your car’s
system. If it is not operating within normal
parameters, we do not recommend the installa-
tion or use of the charge cooler.

For the quickest installation time, we suggest
that you read this manual thoroughly before

beginning. Make sure that you understand the
process, have identified the areas of the car that
you will be working on, and have the tools that
you will need on hand. The average installation
time is 6 to 8 hours, but your time will depend
on your working conditions, experience
installing superchargers, charge cooler, personal
skill level, and preparedness for the job. This
estimate does not include time for the initial
vehicle inspection, cleaning, fine tuning, or trou-
ble-shooting. Once again, we recommend read-
ing the manual before beginning the process. We
are available for tech support at (805) 604-1336,
Monday through Friday, 7AM - 3 PM PST.

After reading the manual, verify that all major
assembly groups are present in the main kit box.
As you remove a box or bag, note the identifica-
tion label and compare it to the parts list.

PAXTON AUTOMOTIVE makes every effort to insure

that all parts are included in the box. If you

discover that you are missing any part,

or that a part was damaged in shipping, call PAXTON

immediately. DO NOT begin installation if a part

is missing. Failure to contact PAXTON prior to

beginning installation will result in a charge for

the missing part.

We suggest that the engine compartment be
cleaned before the installation. You can clean
the engine with a pressure washer that is found

at self-serve car washes. Use a safe-for-alu-
minum cleaner/degreaser, and cover the distribu-
tor and any electronics with a plastic bag to pre-
vent water from entering.