One Systems Cross Field Array – 2 - Manual (Page 7)

SUSPENDING THE CFA-2
The CFA-2 may be suspended using either the stainless steel “U” bracket
(supplied) or by using either the Pole Mount System EX-3 for pole applications or
the PT-76 for either wall or pole mounting. The CFA-2 may be suspended
horizontally using points 1 and 3 shown below via M10 eyebolts.
The CFA-2 rigging points (M10 - 9 points) and mounting point for the “U” bracket
hardware kit (M8 - 1 point (
NOT A SUSPENSION POINT ) are shown below.
The points shown in red are all M10. The single blue colored point is M8. The
points are numbered in this image to illustrate intended usage as follows:
Points 1 and 2……………..”U” Bracket mount (the blue point, M8, is also used for
the “U” bracket strap kit. The blue M8 point is NOT a structural point and is used
for the “U” bracket strap ONLY!)
Points 1 and 3, 4 and 5…….Horizontal enclosure mount.
NOTE: All 4 points,
(Points 1, 3, 4, and 5) must be used for horizontal mount configurations. Point 4
and 5 are for pull up and safety!
Point 6………………………Four points used for either the PT-76 or the Pole
Mount System EX-3 (
NOTE: Point 4 is used for the “link” portion of the PT-76 or
the Pole Mount System EX-3 mounts)