One Systems Cross Field Array – 2 - Manual (Page 2)

The system is also compatible with the One Systems Pole Mount System EX-3 if
vertical tilt requirements are specified in a pole mount application. The One
Systems PT-76 is also compatible with the CFA-2 when pan and tilt are required.
The CFA-2 has an internal 600 watt autoformer and an internal jumper system
that allows the enclosure to be used in either a “Lo Z” (4 ohm) or “Hi Z”
configuration. The autoformer taps are 600 watts, 300 watts, and 150 watts. The
input will allow for either 70.7Vrms operation or 100Vrms operation. The
autoformer is a very low insertion loss (<0.4dB) impedance converter that
exhibits very wide bandwidth.
NOTE: The CFA-2 is factory configured for 4 ohm operation. Internal jumpers are
supplied and must be re-configured for “Hi Z” operation.
System input is a five position barrier strip. The input section features an
aluminum weather cover with an integral IP68 rated glad nut. The gland nut will
accommodate cable outside diameters of 7mm to 12mm (0.236” to 0.472”). The
maximum diameter will accept most 2 conductor AWG12 cable assemblies.
FEATURES AND BENEFITS:
Very High Intelligibility
Long Throw/High Acoustic Output
Fully Rotatable High Frequency Waveguide
IP 56 Direct Weather Rated
Double Large Format High Frequency Drivers
Lo Z and Hi Z User Switchable Operation
2 X 2 10” (254mm) Low Frequency Long Throw Array
Multiple Fly Points and Rigging Accessories