NEXCOM VTC 100 - Manual (Page 17)

Copyright © 2013 NEXCOM International Co., Ltd. All rights reserved 4 VTC 100 User Manual
Chapter 1: Product Introduction
Item Function Description
1 SIM Card Slot
VTC can be internally integrated with a 3.5G Mini Card module. The SIM card bracket is on the carrier board.
When using the GPRS/UMTS/ HSDPA function, insert the SIM card into the SIM card socket. Make sure to turn
off VTC before inserting the SIM card.
2 Power Button
When the ignition is from “low” to “high”, VTC will turn on automatically.
When the ignition is “high”, press the power button 5~6 secs to turn off VTC.
When the ignition is “high”, VTC has been turned off, press the power button 1~2 secs to turn on the system.
When the ignition is from “high” to “low”, VTC will turn off automatically.
When the ignition is “low”, pressing the power button will not turn on VTC.
3 LED indicator
Green is for power on/off status.
Orange is for storage status.
4 Reset Button Press this button to restart VTC.
5 Audio
Line-out.
Line-out is a stereo output for connecting external speakers.
Mic-in.
Mic-in receives monophonic input from an external microphone.
6 USB Port The two USB ports are compliant with USB2.0 specifications.
7 Antenna Holes
The external antenna mounting holes are used to mount and connect the antenna to a WLAN module, WWAN
module and GPS.
8 COM1 RS-232 connector
9 COM2 RS-485 connector
10 LAN Port
The LAN port is an RJ45 interface with integrated LEDs and supports 10/100/1000Mbps Ethernet data transfer
rates.
11 VGA Port The DB15 VGA port supports resolutions of 640 x 480 and 800 x 600
12 GPIO
DB9 female connector for 3 GPIO Input (source type; 0~30V ), Output (sink type;20mA max) and CAN bus
support.
13 Power Input Connector 9 ~ 36VDC power Input.