Hardware specifications – NEXCOM VTC 100 User Manual

Page 15

VTC 100 User Manual

Chapter 1: Product Introduction

Hardware Specifications

MPU
• ARM Cortex™-A8 Processor with 720MHz frequency

Memory
• On-board DDR2 256MB

Expansion

• 1x CAN Bus module with J1939/J1708 for option
• 1x Mini-PCIe socket (USB) x 1 for WWAN option
• 1x Bundle GPS module

I/O Interface-Front

• 2x USB 2.0 host type A connector
• 1x Line-out, 1 x Mic-in
• 1x System reset button
• 2x LED’s for power, storage
• 1x Power button
• 1x SIM card socket
• 4x Antenna hole reserved for SMA-type antenna connector (WWAN/

WLAN)

I/O Interface-Rear

• 1x 9~36VDC input with Ignition and 6W typical power consumption
• 1x DB9 RS-232 (COM1)
• 1x DB9 RS-485 (COM2)
• 1x DB9 female connector for 3GPI and 3GPO
• 1x DB15 VGA
• 1x RJ45 with LEDs for 10/ 100/ 1000Mbps Ethernet
• 1x SMA-type GPS antenna connector
• 1x Antenna hole reserved for SMA-type antenna connector (WWAN/

WLAN)

Expandable Storage

• Micro SDHC Slot (Bundle with 4GB)

Power Management

• Selectable boot-up & shut-down voltage for low power protection
• HW design ready for 8-level delay time on/off at user’s self configuration
• Power on/off ignition, software detectable

Operating System

• Windows Embedded Compact 7
• Linux 3.2