NEXCOM NDiS M324 - Manual (Page 53)

Copyright © 2013 NEXCOM International Co., Ltd. All Rights Reserved. 39 NDiS M324 User Manual
Chapter 4: BIOS Setup
Serial Port 2 Configuration
Device Settings
Displays the IO address and IRQ of serial port 2.
Advanced
Version 2.16.1242. Copyright (C) 2013 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2013 American Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Enable or Disable Serial Port
(COM) Serial Port 2 Configuration
Serial Port
Device Settings
[Enabled]
IO=2F8h; IRQ=3;
IT8528 HW Monitor
This section is used to monitor hardware status such as temperature, fan
speed and voltages.
Advanced
Version 2.16.1242. Copyright (C) 2013 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2013 American Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Select AC power state when
power is re-applied after a power
failure
PC Health Status
System temperature1
System temperature2
Vcore
VIN1
VIN2
VIN3
Fan1 Speed
AC Power Loss
System FAN Speed
FAN Mode
: +30 C
: +29 C
: +0.859 V
: +12.281 V
: +5.167 V
: +3.349 V
: N/A
[Power Off]
[Disable FAN]
[Enable Smart Fan]
AC Power Loss
Power Off When power returns after an AC power failure, the system’s
power is off. You must press the power button to power-on
the system.
Power On When power returns after an AC power failure, the system will
automatically power-on.
System FAN Speed
Enables or disables fan speed control of the system.
FAN Mode
Configures the fan mode. The options are Disable Fan, Enable Smart Fan,
Programming Fan and Always Full Speed.