NEXCOM NIFE 100 User Manual
NEXCOM Hardware
Table of contents
Document Outline
- Preface
- Copyright
- Disclaimer
- Acknowledgements
- Regulatory Compliance Statements
- Declaration of Conformity
- RoHS Compliance
- Warranty and RMA
- Safety Information
- Installation Recommendations
- Safety Precautions
- Technical Support and Assistance
- Conventions Used in this Manual
- Global Service Contact Information
- Package Contents
- Ordering Information
- Chapter 1: Product Introduction
- Chapter 2: Jumpers and Connectors
- Before You Begin
- Precautions
- Jumper Settings
- NIFE 100 and NIFE 101 System Components
- Locations of the Jumpers and Connectors for NIFB 105
- Jumpers
- Connector Pin Definitions
- External I/O Interfaces - Front Panel
- Internal Connectors
- BIOS Pin Header
- RTC Switch
- Power Pin Header
- Signal Pin Header
- SATA Connector (7-pin and 15-pin)
- Port 80 Connector
- Mic-in Pin Header
- Line-out Pin Header
- Line-in Pin Header
- PS2 KB/MS Pin Header
- FAN Connector
- GPIO Pin Header
- LAN1A LED Pin Header
- LAN1B LED Pin Header
- Reset Pin Header
- PWR_LED/HDD_LED/SMB_BUS/S3/SW_ON/RESET
- 3.5G Line-out Pin Header
- 3.5G Mic Pin Header
- Power Pin Header
- SIM Card Connector
- Mini-PCIe Connector
- Locations of the Jumpers and Connectors for the I/O Daughterboard
- Connector Pin Definitions
- Chapter 3: System Setup
- Chapter 4: BIOS Setup
- Appendix A: Power Consumption
- Appendix B: GPI/O Programming Guide
- Appendix C: Watchdog Timer Setting