NEXCOM NIFE 100 User Manual
Page 69
Copyright © 2015 NEXCOM International Co., Ltd. All Rights Reserved.
55
NIFE 100/101 User Manual
Chapter 4: BIOS Setup
IDE Configuration
This section is used to configure the SATA drives.
Advanced
Version 2.16.1242. Copyright (C) 2013 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2013 American Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Enable / Disable Serial ATA.
IDE Configuration
Serial-ATA (SATA)
SATA Mode
Serial-ATA Port 0
SATA Port0 HotPlug
Serial-ATA Port 1
SATA Port1 HotPlug
SATA Port0
Not Present
SATA Port1
Not Present
[Enabled]
[AHCI Mode]
[Enabled]
[Disabled]
[Enabled]
[Disabled]
Serial-ATA (SATA)
Enables or disables SATA device.
Serial-ATA Port 0 and Serial-ATA Port 1
Enables or disables SATA port 0 and SATA port 1.
SATA Port1 Hotplug and SATA Port2 Hotplug
Enables or disables hotplug support on SATA port 1 and SATA port 2.
SATA Mode
Configures the SATA as IDE or AHCI mode.
IDE
This option configures the Serial ATA drives as Parallel ATA
physical storage device.
AHCI
This option configures the Serial ATA drives to use AHCI
(Advanced Host Controller Interface). AHCI allows the storage
driver to enable the advanced Serial ATA features which will
increase storage performance.