Sata configuration – NEXCOM PEAK 887VL2 User Manual
Page 42
Copyright © 2013 NEXCOM International Co., Ltd. All Rights Reserved.
28
PEAK 887VL2 User Manual
Chapter 3: BIOS Setup
Advanced
Version 2.15.1236. Copyright (C) 2012 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Enable or disable SATA Device.
SATA Controller(s)
[Enabled]
SATA Mode Selection
[IDE]
SATA Controller Speed
[Gen2]
Serial ATA Port 0
Empty
Software Preserve
Unknown
Serial ATA Port 1
Empty
Software Preserve
Unknown
Serial ATA Port 2
Empty
Software Preserve
Unknown
Serial ATA Port 3
Empty
Software Preserve
Unknown
Serial ATA Port 4
Empty
Software Preserve
Unknown
Serial ATA Port 5
Empty
Software Preserve
Unknown
SATA Configuration
This section is used to configure the SATA drives.
SATA Controller(s)
Enables or disables the SATA controller.
SATA Mode Selection
Configures the SATA as IDE, AHCI or RAID mode.
IDE
This option configures the Serial ATA drives as Parallel ATA
physical storage device.
RAID
This option allows you to create RAID or Intel Matrix Storage
configuration on Serial ATA devices.
AHCI
This option configures the Serial ATA drives to use AHCI
(Advanced Host Controller Interface). AHCI allows the storage
driver to enable the advanced Serial ATA features which will
increase storage performance.
SATA Controller Speed
Configures the speed of the SATA controller.