Uefi s, Hapter, Etup – NEXCOM NEX 980 User Manual

Page 31: Tility, 1 introduction

NEX 980 User Manual

Chapter 3: UEFI Setup Utility

3.1 Introduction

This section explains how to use the UEFI Setup Utility to configure your
system. The UEFI chip on the motherboard stores the UEFI Setup Utility. You
may run the UEFI Setup Utility when you start up the computer. Please press
or during the Power-On-Self-Test (POST) to enter the UEFI Setup
Utility, otherwise, POST will continue with its test routines.

If you wish to enter the UEFI Setup Utility after POST, restart the system by
pressing + + , or by pressing the reset button on the
system chassis. You may also restart by turning the system off and then
back on.

haPter

3: uefI s

etuP

tIlIty

3.1.1 UEFI Menu Bar

The top of the screen has a menu bar with the following selections:

Main

To set up the system time/date information

Advanced

To set up the advanced UEFI features

H/W Monitor

To display current hardware status

Boot

To set up the default system device to locate and load
the Operating System

Security

To set up the security features

Exit

To exit the current screen or the UEFI Setup Utility

Use <

> key or < > key to choose among the selections on the menu

bar, and then press to get into the sub screen. You can also use the
mouse to click your required item.

Because the UEFI software is constantly being updated,
the following UEFI setup screens and descriptions are for
reference purpose only, and they may not exactly match what
you see on your screen.