NEXCOM NEX 716VL2G - Manual (Page 48)

47 Chapter 4 NEX716VL2G User Manual
ACPI Function
The ACPI standard (Advanced Configuration and Interface power) allows the operating s ystem direc tly to
chec k the functions of energy saving and the PnP (P lug and Play) functionality. The ACPI functions are
normally activated by the BIOS. The choices are: Enabled and Disabled.
Power Management
This category allows you to select the type (or degree) of power saving and is directly related to the following
modes: HDD Power Down, Doze Mode and Suspend Mode
w
Min. Saving: Minimum power management
w
Max Saving: Maximum power management
w
User Define: Allows you to set each mode individually
Video Off Method
This determines the manner in which the monitor is blanked. There are three choices:
1. V/H SYNC+Blank: This selection will cause the system to turn off the vertical and horizontal
synchronization port and writ e blanks to the video buffer.
2. Blank Screen: This option only writes blanks to the video buffer.
3. DPMS Support: Select this option if your monitor supports the Display Power Management
signaling (DPMS) standard of the Video Electronics Standard to select video power management
values.
Video Off in Suspend
This determines the manner in which the monitor is blanked. The choices: Yes, No.
Suspend Type
Select the Suspend Type. the choices: PwrOn Suspend and Stop Grant.
MODEM Use IRQ
This determines the IRQ in which the MODEM can use. The choices are 3, 4, 5, 7, 9, 10, 11, and NA.
Soft-Off by PWR-BTTN
This function can turn the system off with the on/off butt on places the system in a very low-power-usage
state, with only enough circuitry receiving power to detect power button activity or Resume by Ring activity.
The choices are Delay 4 seconds, and Instant-Off.