NEXCOM ICES 268 - Manual (Page 89)

Copyright © 2013 NEXCOM International Co., Ltd. All Rights Reserved. 75 ICEK 268-T2 Starter Kit User Manual
Chapter 4: BIOS Setup
Parallel Port Configuration
This section is used to configure the parallel port.
CPU PPM Configuration
This section is used to configure the Processor Power Management (PPM)
configuration.
Parallel Port
Enables or disables the parallel port.
Change Settings
Selects an optimal setting for the Super IO device.
Device Mode
Configures the operating mode of the parallel port.
Advanced
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Enable or Disable Parallel Port
(LPT/LPTE) Parallel Port Configuration
Parallel Port
Device Settings
Change Settings
Device Mode
[Enabled]
IO=378h; IRQ=5;
[Auto]
[STD Printer Mode]
Advanced
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Enable/Disable Intel SpeedStep CPU PPM Configuration
EIST
CPU C3 Report
CPU C6 report
CPU C7 report
[Disabled]
[Disabled]
[Disabled]
[Disabled]
EIST
Enables or disables Intel ® SpeedStep.
CPU C3 Report
Enables or disables C3 report to the operating system.
CPU C6 Report
Enables or disables C6 report to the operating system.
CPU C7 Report
Enables or disables C7 report to the operating system.