NEXCOM ICES 268 - Manual (Page 87)

Copyright © 2013 NEXCOM International Co., Ltd. All Rights Reserved. 73 ICEK 268-T2 Starter Kit User Manual
Chapter 4: BIOS Setup
W83627DHG Super IO Configuration
This section is used to configure serial ports 0 and 1, floppy disk and parallel
port.
W83627DHG Super IO Chip
Displays the Super I/O chip used on the board.
Advanced
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Set Parameters of Floppy Disk
Controller (FDC) W83627DHG Super IO Configuration
W83627DHG Super IO Chip
 Floppy Disk Controller Configuration
 Serial Port 0 Configuration
 Serial Port 1 Configuration
 Parallel Port Configuration
W83627DHG
Floppy Disk Controller Configuration
This section is used to configure the floppy disk controller.
Serial Port
Enables or disables the floppy disk controller.
Change Settings
Selects an optimal setting for the Super IO device.
Device Mode
Changes the mode of the floppy disk controller. Select ‘Read Write’ for
normal operation. Select ‘Write Protect’ mode for read only operation.
Advanced
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Enable or Disable Floppy Disk
Controller Floppy Disk Controller Configuration
Floppy Disk Controller
Device Settings
Change Settings
Device Mode
[Enabled]
IO=3F0h; IRQ=6; DMA=2
[Auto]
[Read Write]