Neotech Communications HGSW-42SHP - Manual (Page 4)

HGSW-42SHP
Self-Configured Hardened 4-port 10/100/1000Base-T + 2-port 1000Base-X SFP Ethernet Switch with PoE+/PSE
4 V1.0
Setup
1. Connect one end of the Ethernet cables to their corresponding ports on the product. Connect the
other end to the network equipment such as IP cameras, Switches or PCs. Insert the SFP and
connect the optical fiber cables to its connectors.
2. Connect the product with the power adapter and switch on the product, the PWR indicator should
then be ON. If it is not, please check whether the power cable is connected properly and the power
supply functions normally.
After all cables are connected, corresponding indicators will be on. Please refer to the Operational
Instructions for detail descriptions.
Interface
RJ-45 Pin Assignment
Pin Signal Name
1 TP0+
2 TP0-
3 TP1+
4 TP2+
5 TP2-
6 TP1-
7 TP3+
8 TP3-
Power and Alarm Connection：
Pin
Description
V1 - V1 + ALM V2 - V2 +
Power Input GND
+48V
(DC)
Normal Open GND
+48V
(DC)
Cable Connections
Signal Type Cable Type Connector
Ethernet Cat. 5 or above RJ45
Optical SM/MM Optical fiber cable (depends on SFP) LC
Power supply 1 Power cable 6-pin Terminal Block（Pin 1/2）
Power supply 2 Power cable 6-pin Terminal Block（Pin 5/6）
ALM 2 wire 6-pin Terminal Block（Pin 3/4）