Setting up the net burner – Monroe Electronics 639 User Manual
Page 7
7
SETTING UP THE NET BURNER
A manual and a program for the 639 entitled IPSetup.EXE is included on the
CD provided with the unit.
Make sure that the 639 to be set up is powered up, and is connected to your
computer or to your network, before opening this program. [If connecting di-
rectly from your computer, use a crossover cable.]
Notice, in the screen shot above that a 639 has been detected.
If this unit has not been set up, it will have a default of 192.168.0.2. However,
this particular device has been set up already. This should be one of the choices
shown in the screen shot from your device.
To change this to the IP address you desire, merely type into the NDK Settings
the address IP, the Gateway and the DNS on the left side to program this
address. Then click on ‘Set’, and the program will modify your device.
Select Close to finish.