Junger Audio b43 - Digital Audio Toolbox - Manual (Page 24)

5. SETUP
page 5-4 operation manual b43, chapter 5 -Setup-
In this menu it can selected if either the running parameter set
will be changed or if an already saved preset will be edited.
Turn the control knob to change the selection. Push the knob to
ENTER the selection and to go to the next menu.
Adjusting the current parameter set is immediately proceeded
by the DSP and therefore an audible change of the processing.
Editing already existing presets is just changing the saved data
of the related preset. Done changes will be first time valid with
the next recall of the preset.
There are four windows showing the selection and the settings
either for input channels 1/2 or for input channels 3/4.
INPUT 1/2 (3/4): AES
TRANSPARENT: OFF
input selection 1/2 (3/4):
transparent mode 1/2 (3/4):
AES or SDI (if installed) OFF or ON (input direct
feeded to output)
IN 1(3): 0.0 t: 0 ms
IN 2(4): 0.0 t: 0 ms
selected input channel
input gain setting
delay time setting
(-15.0 ... +15.0dB) (0…160ms)
There are two windows showing the settings either for output
channels 1/2 or for output channels 3/4.
OUT 1(3): 0.0
∑: 2 + 3
OUT 2(4): 0.0
∑: 1 + 2 + 4
selected output channel
output gain setting
(-15.0 ... +15.0dB)
mix matrix setting
(sum of mixed input channels for one output)
5.5
EDIT
SELECTION
MENU
5.6
INPUT
SETUP MENU
5.7
OUTPUT
SETUP MENU