Junger Audio b43 - Digital Audio Toolbox - Manual (Page 10)

2. FUNCTION DESCRIPTION
There are two level displays available - input level and output
level display (For all four channels). The audio level is
displayed as bargraph. This display is not scaled. Two
segments are appr. 2dB of audio level. The level display gives
information about the existence and the size of the audio
signals.
2.4
LEVEL DISPLAY
I 1: IIIIIII i 2:
IIIIIII
i 3: IIII i 4:
IIIIIIIIII
I = input level O = output level
Only the output level display can show an overload. If an
overload appears, the output level display shows the
corresponding „OVER“-message.
2.5
REMOTE SYSTEM
The digital audio toolbox b43 is fitted with an serial remote
interface in RS-422 format.
Every device needs a device address to be registered in a
remote system. The address can be selected with the ADDR
switch on the rear panel. 16 addresses are selectable (0..F).
The changed address is valid with next power-on reset.
Up to 16 toolboxes b43 can be controlled from one remote panel.
Device model name and device address are to recognize using
the remote protocol of serial remote interface by an automation
system or by PC. With it various boxes can be combined in one
remote system or remote chain. However a maximum of 16
devices per model can be controlled in one chain.
page 2-4 operation manual b43, chapter 2 -Function description-