Junger Audio b43 - Digital Audio Toolbox User Manual
Page 20
4. LOCATION OF PARTS AND CONTROLS
Units with SDI interface can be used in SDI split mode:
Audio in path
SDI input > AES output
Audio out path
SDI output > dsp processing > AES output
(see also 2.5)
dsp
processing
AES
out
SDI
out
SDI
in
B4x
Split Mode
AES
in
External device
AES
in
AES
out
The selection of split mode (SPLIT) is made by setting jumper
J1 on main board of the unit.
The 4-channel processors of b40 series fitted with SDI-interface are
compatibel with the standard SMPTE 272M-AB. They support 48 kHz
synchronous audio sampling with 20 bit word length.
The standard allows up to four groups each of four mono audio channels.
(Usually used by most of D-VTR's and other equipment is Group 1 with 48
kHz synchronous sampling.)
Group selection and other settings are made by the front panel switches.
Therefore no switches on the SDI board has to be used.
4.4
SELECTION OF
SDI SPLIT MODE
4.5
CONFIGURATION
OF SDI INTERFACE
page 4-4 Operation manual b43, chapter 4 -location of parts and controls-