Junger Audio C8612 - Dolby® D/D+/AAC encoder - Manual (Page 10)

digital audio
modular
processing system
C8000
Dolby Digital / Digtal plus / Pulse (AAC) encoder
C8612
10/20
From C8000 System Bus
The audio busses from the C8k frame must be assigned to the
respective encoder channels. This can be done in 2 or 8ch mux
mode. If the module is connected to a bus that is in 8ch mux mode
(e.g. S9), signal pairs my be taken from there or from individual 2ch
mux busses (e.g. S1).
Gain [-10.0 … 0.0 … 10.0]
dB An additional gain stage is available here to align the level prior to
encoding.
Encoder 1 / Encoder 2 Graphical representation of the two encoders used by the
C8612 module.
To C8000 System Bus [S1 … S32, OFF]
The two encoder outputs may be assigned to C8k busses as well
as alternately to the external BNC monitor output.
Channel Status [Professional, Consumer]
The AES channel status for the encoded streams my be switched
from Professional to Consumer format.
Enable Bus Driver You may turn off all bus drivers (tri state mode) for installation
to prevent conflicts with modules already in service.
Error Detection [Off / On]
The serial audio data from the frame bus can be monitored for
proper positioning of an Error-Flag. A wrong detection is an
indication that there is disturbance upstream
(input signal lost, input module broken, upstream module failure).