Junger Audio X*AP RM1 - Manual (Page 6)

X*AP RM
1
2
Introduction
At the heart of the X*AP RM
1 works a high power 32bit embedded micro controller.
It runs a web server for browser based settings and firmware updates.
The communication protocol is EmBER+. So any device that speaks this protocol may easily be controlled by
the X*AP RM
1 .
In the devices routing paths, the enabling and disabling of audio processing blocks and the setting of
processing parameters can be pre configured by individual presets dedicated to each function block.
These presets may either be recalled on demand by the operator via the GUI, the X*AP RM
1 remote panel
Hot Keys or play-out automation systems.
The X*AP RM
1 remote panel functions are for now limited to operating needs rather than setting up a device.
Beside the pre-configured key functions like loudness measurement or speaker control, the 8 Hot-Keys may
be programmed by the administrator.
Hardware concept
The X*AP RM
1 remote panel may be used stand alone or may be attached to a 1RU device that has a front
panel RJ45 socket. E.g. older versions of the D*AP8 base unit have such a socket. If it is attached to a
dedicated device by brackets it is highly recommend to support the chassis by additional brackets screwed to
the rear as shown above or by metal angles supporting the device from the bottom.
The X*AP RM
1 remote panel is powered by POE (Power Over Ethernet). If it must be connected via a router
of the network, this router must have a free POE (Power Over Ethernet) port. If this is not the case, you must
use the wall plug POE power supply that comes with the X*AP RM
1 .