Junger Audio X*AP RM1 - Manual (Page 15)

X*AP RM
1
11
Safety information
Electrical
Safety classification : Class 1 – grounded product / Schutzklasse 1
Corresponding to EN 60065:2002
Power connection : The device must be connected to a Power Over Ethernet capable switch, to a
D*AP8 or other Junger devices or to a wall plug power supply.
Water protection : The device must not be exposed to splash or dripping water.
It is permitted to place a container filled with liquids (e.g. vases)
on top of the device.
Service safety
Only qualified personnel should perform service procedures.
Do not service alone : Do not perform internal service or adjustments of the device unless another
person capable of rendering first aid and resuscitation is present.
To avoid fire or personal injury
Mounting : It must be placed on a flat surface or must be mounted into an 19" rack.
Provide proper this case and if the device has a built in fan, a gap of at least 1cm must be
Ventilation left between the device edge and the steel angle. It is highly recommended to
leave a gap of at least 1RU above and below the device.
Do not operate Do not operate this product with covers or panels removed.
without covers
Do not operate If you suspect that there is damage to this product, have it inspected by
with suspected failures by qualified service personnel.
Risk of explosion : The device contains a lithium battery. If replaced incorrectly or by a different
or inadequate type an explosion may occur.
Warranty
standard Junger Audio two-year warranty on parts and labor.
Specifications are subject to change without notice