Junger Audio X*AP RM1 - Manual (Page 11)

X*AP RM
1
7
Operating - menu structure of the X*AP RM 1 remote panel
This example assumes that the X*AP is attached to a Television Audio Processor T*AP
(other devices will appear differently) :
When pressing the
The Audio Processor has the following functions available which you can reach by the F-Keys :
#1 #2 #3<Equalizer> #4>
#5 #6 #7 #8
Operating – menu structure of the X*AP RM 1 remote panel - principle of operation
If you are in a specific parameter menu the display structure may change due to the program configuration of
the T*AP. Below is an example for setting the parameters for the Dynamics (F-Key #5) while the T*AP is in
5.1 + 2 program configuration and operates in ITU mode. In this case you have two parameter sets for the
first program: ALL and LFE (if the LFE is not linked).
Since the Dynamics have two subsections: Expander and Compressor, this menu has two pages,
indicated by the number in the top right hand corner :
You may switch between both pages with the button
toggles between the two parameter sets ALL / LFE. The parameter set under control is
highlighted. If for example you now press , the Release setting for the LFE will be enabled and the
Rotary Encoder is also illuminated. You may now change the Ratio by turning the knob.
toggles between Program 1 (5.1) and Program 2 (1x2).
MENU
ESC
Menu T*AP 10.110.64.128
Audio
Processor
EBU R 128
Meter
MENU
ESC
Hotkey 1 Hotkey 2 Hotkey 3 Hotkey 4 Hotkey 5 Hotkey 6 Hotkey 7 Hotkey 8
Program 1 Program 2
-21.0
LUFS
-21.5
LUFS
EBU
S
out
MENU
ESC
Expander On Threshold [dB] Range[dB]
LFE
ALL On -60 10.0
Program 1
On -60 10.0
Release 1/2
4
4