D-Link DES-2218 - Manual (Page 63)

DES-2218 Ethernet Switch User’s Guide
Using the Console Interface
51
Figure 6-21. Statistics Counters
You can use the PREPORT, and NEXTPORT commands to switch ports.
The CLEAR COUNTER command will start all of the counters over at 0.
Resetting the Switch
You can use the console interface to reset the switch, either doing a System
Reset (which restarts the switch and is identical to powering the switch off
and back on again) or a Factory Reset (which sets all of the switch’s
parameters to what they were when the switch was delivered from the
factory).
System Reset
To perform a system reset,
1. Choose System Reset from the main menu.