Daewoo SH-3510P - Manual (Page 28)

26
Timer Recording
■ For timer recordings, clock, date, and stations must be set correctly.
■ Load a cassette with its safety tab in place and with sufficient free space for the recording.
Call up the VideoPlus menu by pressing PROGRAM on the
remote control.
From your TV magazine, type in the number next to the
programme you want to record ...
... and confirm.
1
Decide if you want to record "ONCE", "WEEKLY" or "DAILY"...
... and confirm.
2
If you wish to make changes:
Move to the position you want to change using the [œ
œ/√ √]
buttons.
Change the setting using the […
…/† †] or [number] buttons. If all
setting are ok, press [OK], till you see “OK: CONFIRM” in the
bottom line.
Confirm.
3
Switch your player off.
0-9:VIDEOPLUS NUMBER
:CORRECT
OK:CONFIRM SETUP:END
VIDEOPLUS
83077----
HOW OFTEN DO YOU WANT
TO RECORD THIS PROGRAM?
PR+/-:SELECT
OK:CONFIRM SETUP:END
TIMER PROGRAM (ONCE)
PR 03
START TIME 21:20
END TIME 22:20
START DATE 14/08(SAT)
TAPE SPEED SP
VPS/PDC ON
PR+/-:SELECT (AV1/AV2)
0-9 : SETUP (PR)
/➝ :CORRECT
OK:CONFIRM SETUP:END
ONCE
WEEKLY(ONCE A WEEK)
DAILY(MON-FRI)
DAILY(MON-SAT)
DAILY(MON-SUN)
Timer recording using VideoPlus (SH-9840P only)
• VPS/PDC is a service provided by some stations to enable you to perform timer recordings
precisely even if the broadcaster delays the start time of the programme slightly. The time you enter
is the VPS/PDC time so must be correct. Not all stations offer VPS/PDC, in which case the player
will start at the time you enter and not the actual start time of the programme.
If you wish to start recording at a specific time without it being adjusted by the VPS/PDC system
in the event of a delay, switch VPS/PDC off otherwise the player will not record at the preset time.
• If you don’t have the VIDEOPLUS numbers see next page for the normal timer operation.
• If you have made a mistake, move back to the relevant position with the [œ
œ ] button and change
the setting.
• If there is no programme location displayed under “PR” in the change menu, the player doesn’t
yet know the location number for the programme you want. Type it in and this will be stored
for last recordings.
• If you wish to record from a satellite receiver, select under “PR” the satellite programme
location or AV (1/2) (depending on the connection with the antenna cable or the SCART-cable).
Leave the satellite tuner turned on and switched to the programme you want.
• Should programming overlap, you get a warning.
• To cancel the recording press the button (stop) for more than 5 seconds.
• VIDEOPLUS is a trademark applied for by Gemstar Development Corp.. The VIDEOPLUS
system is manufactured under license from Gemstar Development Corporation.
➝
➝