Desa TD100 - Manual (Page 5)

www.desatech.com 118994-01G 5
ASSEMbLy
Estimated assembly time: 45 minutes
Tools required:
• # Phillips screwdriver
• 9/16" and 5/16" Open end wrenches
Hardware packet provided with heater may
contain more parts than needed for heater
assembly.
Hardware packet contains the following items
shown on pages 10 through 13:
Electronic Ignitor (1), Ignitor Wire (1), Ground
Wire (1), Valve Knob (1), Propane Tank Reten-
tion Chain (1), Retention Hook (), D Batteries ()
and AA Battery (1).
Parts are referenced by designated letter
throughout assembly instructions. Hardware
packet contains the following (quantity used
in parenthesis):
Description Part No.
A 1 1 / " Screw (8) 119619-01
B 7 mm Washer (8) 119600-04
C 5/8" Screw (9) 119619-03
D 5 mm Washer (9) 119600-0
E Hex Nut No. 10 (9) NPC-3C
F 3/8" Screw (0) 119619-06
G Hex Nut (0) NPC-1C
H 3/8" Self tapping screw (34) 11960-0
I
1 /
4
" Hex Bolt () HC4-18C
J 5/16" Hex Nut () NPC-5C
Figure 4 - Cabinet Base Assembly
Cabinet
Base
Tank
Door
Base
Ignitor
Retainer
Ring
Ignitor
Cap
BASE ASSEMBLY
1. Turn base upside down. Attach wheels,
axles (I) and nuts (J) as shown in
Figure 3. Do not overtighten.
. Attach 4 base feet to base weight with 4
washers (B) and 4 screws (A) as shown
in Figure 4. Feet will install over raised
areas underneath base weight.
3. Being careful not to scratch paint, lay cabinet
base onto back side (use foam packaging
block to support rear top of cabinet base).
Align holes in bottom edges of cabinet base
with holes in base as shown in Figure 4.
Attach with 1 screw (C), 1 washer (D) and
1 nut (E) for each of the 9 holes (see Figure
4). Set assembly upright.
4. Attach base to weight with 4 screws (A)
and 4 washers (B) as shown in Figure 4.
A
F
H
B
J
C
D
E
G
I
Base
Weight
Base Foot,
Washer and
Hex Bolt
Figure 3 - Attaching Wheels to Base
Base
Wheel
Nut
Axle
5. Install chain retainers (“S” hooks) to upper
edges of cabinet base as shown in Figure 4.
6. Install electronic ignitor through cabinet
wall as shown in Figure 4. Hand tighten.
7. Attach tank door to cabinet with 4 screws
(F) and 4 nuts (G) as shown in Figure 4.
Set entire assembly aside.
Chain
Retainer