Cleaning of rollers, Laminating film – Drylam Fujipla LPE3510 Roller Laminator User Manual
Page 9
6. CLEANING OF ROLLERS:
Clean rollers when necessary. An excess of adhesive stuck to the rollers may cause film jamming.
Fold a sheet of paper (e.g. calendar, catalogue, etc.) in two.
Insert the paper several times between the rollers with folded side first.
Cleaning periodically by wiping with a rag soaked with methyl or ethyl alcohol is recommended because old
adhesive cannot be easily removed.
Never use organic solvents (toluene, benzene, thinner, etc.).
Do not use thin paper (e.g. copying paper) for the cleaning of the rollers as it may cause jamming.
Do not use metal or sharp materials to remove glue from rollers.
Use Dry-Lam’s Maintenance Kit (part number 01300) to lubricate the face of the Heat Chambers between film roll
changes. Doing so will allow film to pass effortlessly over them producing higher quality laminations with less back-
tension from the Chambers. The lubricate will also increase the effective life of the chambers. See your dealer or contact
Dry-Lam for this part.
7. LAMINATING FILM
It is recommended to use Fujipla, Dry-Lam, or other quality films. See your dealer.