Drylam Fujipla LPE3510 Roller Laminator - Manual (Page 8)

4. OPERATION (cont’d):
Creases or wrinkles may appear in the film as it exits the rear
of the machine. Observe the film at the face of the Heat
Chambers. There may be the occurrence of creases or
“waterfall” of the film along the chambers. They should
disappear shortly. If they do not disappear, adjust the film
tension.
• To increase tension, rotate Tension Controller
clockwise.
• To decrease tension, rotate Tension Controller
counter- clockwise.
Notes:
During lamination, be sure that Safety Cover and Feed Table
are securely set.
If READY lamp does not glow stop the lamination until the
lamp glows again.
Rollers rotate in reverse when Motor Switch is turned to
REV. Do not use this function except in case of emergency.
If the REV is used film may back up into the lamination area
and cause a jam.
5. FINISH OF LAMINATION:
Switch OFF Motor Switch.
Turn off the Power Switch, and unplug.