Drylam Fujipla LPE3510 Roller Laminator - Manual (Page 4)

SAFETY PRECAUTIONS:
For safe operation, be sure to observe following precautions.
Installation:
1. Do not install the Lamipacker in a humid, dusty area, or near an air conditioner.
2. Install Lamipacker on a level surface and leave enough space in the rear to guide laminated objects out the exit.
3. Do not put anything on top of the Lamipacker.
4. Be certain that the power source connects to a dedicated and grounded AC120V 60 Hz outlet. Do not share the
electrical outlet with other devices.
5. Use in a well ventilated room.
Laminat ing film:
• While genuine FUJIPLA "CP Roll" is recommended any quality 1.5 or 3 mil laminating film may be used. Contact
your dealer.
Laminating objects:
Lamination is made by heat and pressure. Inappropriate operation may cause failure in quality of lamination or in
jamming of film. Avoid lamination of the following:
• Inflammable substances or any substance susceptible to heat (e.g. vinyl chloride, polyethylene, etc.)
• Valuable items which are unique and not replaceable. Do not laminate money.
• Lamination items which exceed 35mil. In total thickness.
• Objects which change color or quality with heat (e.g. thermal paper, pictures drawn with crayon etc.)
Operation:
• Operate the Lamipacker only for lamination of paper items.
• Do not leave the Lamipacker
during operation.
1. NAMES AND
FUNCTIONS:
Name of Components
1. Mandrels
2. Heat Shoe and Heat Rollers
3. Safety Cover
4. Tension Controllers
5. Upper Guide Roller
6. Operation Lever
7. READY Lamp
8. Control Dial
9. Power Switch
10. Motor Switch
11. POWER Lamp
12. Front Guide Plate
13. Rear Tray
14. Power Cord
15. Feed Tray
16. Lower Guide Roller