Doremi LE100 - Manual (Page 41)

LE1.OM.002066.DRM Page 41 of 52 Version 1.1
Doremi Labs
12.5 Network Streamer
The LE100 is capable of outputting a standard transport stream over the network. The transport
stream output from the LE100 will be the output of an incoming network signal or, with a satellite
receiver card installed (LE100-SR), the output of either satellite input. This is controlled on the
Network Streamer page.
 Log into the LE100 Web GUI, go to the Control tab and click on the Network Streamer
link on the left side of the GUI (see Figure 26).

Select the desired network output.
o The network outputs can be configured (interface, IP address, port) on the Input
Feed Manager Output Configuration page (see Section 7).
 Then choose the input stream (in the "source" select box).
Note: The satellite sources are only displayed on LE100-SR or if the correct satellite board
is properly installed.
 Next, select the desired program, video, audio and subtitles.
 Settings are automatically saved when modified.
 If the source settings are valid, the Input Status will display green for Running, Signal
Lock and Status.
 The stream will be available once the “Start” button is selected.
 To stop outputting the transport stream, select the “Stop” button.
Figure 26: Network Streamer
Start/Stop
Stream Buttons
Network
Streamer Link