T2-mi over ip output settings, Dtc-378 t2xpress – DekTec DTC-378 T2Xpress User Manual
Page 17

© 2009-2015 DekTec Digital Video BV
Page 17/27
DTC-378 T2Xpress Manual
Essential Tools for Digital-TV Professionals
February 2015
DTC-378 T2Xpress
7.9.4. T2-MI over IP Output settings
In case the output type T2-MI over IP is selected this area allows the selection of the IP output
adapter, IP-transmission parameters and the Transport-Stream parameters.
T2-MI over ASI settings
- IP
The IP-address and port number used for transmission.
- TTL
Time-To-Live value used for transmission.
- Protocol
Protocol used for Transmission: UDP or RTP.
- FEC
Error correction mode used.
- TP/IP
Number of Transport Packets (TPs) stored in one IP packet.
- Encode FEF
If checked outputs a FEF part composite packet with the required subpart; otherwise, only
outputs a FEF part NULL packet when FEF is enabled.
- TS rate
The rate of the output Transport Stream.
- Ext. time ref.
External time reference clock used; when checked the T2-MI stream is synchronized with the
Windows system time.
Note: In this case Windows system time has to synchronize with the external time reference.
- Data PID
The PID of the Transport Stream packets carrying the T2-MI data.
- PMT PID
The PID of the PMT-table that refers to the T2-MI data stream. If a PMT PID is specified a PAT-
table is also added to the stream. If None (-1) is selected, no PAT-table and no PMT-table are
added to the stream.