DekTec DTC-378 T2Xpress - Manual (Page 11)

© 2009-2015 DekTec Digital Video BV Page 11/27 DTC-378 T2Xpress Manual
Essential Tools for Digital-TV Professionals February 2015
DTC-378 T2Xpress
Version DVB-T2 version selection: 1.1.1, 1.2.1 or 1.3.1
Profile DVB-T2 profile selection: Base or Lite
T2 Base Lite T2 Base Lite flag to indicate that the T2-base profile parameters must be
consistent with the T2-lite profile restrictions.
NW ID Network ID. Uniquely identifies the DVB-T2 network
T2 ID T2 System ID. Uniquely identifies a T2 system within the DVB-T2 network
Cell ID Cell ID. Uniquely identifies a geographic cell in a DVB-T2 network
7.4. T2-Frame Parameters
This group of parameters allows you to specify the DVB-T2 frame structure.
DVB-T2 frame related parameters
Parameter Description
#Frames per superframe The number of T2-frames in a super frame
#Subslices The number of sub-slices per T2-frame for each RF channel
#Data syms The number of data OFDM symbols per T2-frame, excluding P1 and P2
RBM validation If checked, Receiver Buffer Model (RBM) validation is performed. In case
errors are detected, they are reported in the “Messages” tab.
Note that RMB validation uses some extra CPU time, therefore it can’t be
executed real-time for all parameter settings.
If the DVB-T2 parameter set is valid, this area also displays the derived frame information.
Parameter Description
Optimum #subslices The largest allowable sub-slicing value
Frame size The total number of cells per T2-frame
Duration The duration of a T2-frame in number of elementary periods
Bitrate The total Transport Stream bitrate of the PLPs
L1 pre+post The number of L1 signalling cells in a T2-frame
#Data cells The number of data cells in a T2-frame
#Dummy cells The number of dummy cells in a T2-frame