Dataman Vali-Flash 2.0 User Manual
Page 3
Dataman Vali-Flash User Manual
Page 3 of 13
INSTALLATION
1. To use the USB CompactFlash card reader to validate your devices, please install
the Memorex CompactFlash card reader and the drivers from the Memorex CD.
2. Once you have installed the hardware and it’s accompanying drivers, you can
proceed with the installation of the Vali-Flash software.
3. To install the Vali-Flash software, follow the normal installation procedure used
for all Windows based programs. The installation program should automatically
launch when the CD-ROM is inserted in your CD drive. If for any reason it does
not, then simply RUN “setup.exe” from the CD-ROM.
NOTE: After you have installed the Vali-Flash program onto your system, you must
run the “Test” program. This program will test your system to make sure that there
are no conflicts between any CompactFlash device and any of your installed hard
disks. To run this program click on the Windows Start button, then Run. Type in
the name Test from the directory where you installed the Vali-Flash program then
click ok. If there are no conflicts, the program will report no conflicts. If there are
any conflicts, the program will report the drives in conflict. If this happens, call
Dataman Support before proceeding any further. Failure to do so could result in loss
of data on your system.