CUE keypadCUE-8 - Manual (Page 9)

3. When changing the label, it is necessary to remove the transparent cover carefully. Use
a small screwdriver to do this. Insert the screwdriver into the small slot in the bottom part of
the cover. Bend the middle part of the cover carefully until the cover is released on one side.
Then remove the whole cover.
3.2.2. Using the final engraved button labels
Steps:
1. Have the labels engraved on the rear surface of the plastic stripes of the front panel. Labels
must be engraved specularly. Recommended fonts are Nimbus, Trebuchet, Verdana or Arial,
size 9 points, bold.
2. Place the stripes onto the keypad, using the same procedure as described in the previous
chapter (on placing the transparent cover over paper labels).
3. Engraved strips do not have slots for easy removing because of design reasons. If you do
need to remove the engraved strip, stick some tool to the centre of the strip using a piece of
double-sided foam adhesive tape. Then lift the central part of the strip, insert a screwdriver
under it and bend the strip slightly until it is released on one side. Then you can remove the
strip.
User Manual keypadCUE-8
www.cuesystem.com
Page 9 of 20