CP Electronics MWS5-SA - Manual

Overview
The MWS5 series of miniature microwave presence
detectors provide automatic control of lighting loads with
optional manual control. As a standalone product it is
designed to be fitted unobtrusively into ceiling tiles or solid
ceilings using the supplied clips.
Three models are available: premium, direct dim, and
analogue dim all of which will switch incandescent,
fluorescent and compact fluorescent lighting. The direct
dim variant controls DALI or DSI digital dimming ballasts
whilst the analogue dim variant controls 1-10V dimming
ballasts.
The unit detects movement using a microwave sensor and
turns the load on. When an area is no longer occupied the
load will switch off after an adjustable time out period.
All functionality is fully programmable using an IR handset.
Features
Miniature Microwave Presence Detector (standalone)
MWS5
Product Guide
Power supply
Microwave Sensor
Detects movement within the unit’s detection range,
allowing load control in response to changes in occupancy.
IR Receiver
Receives control and programming commands from an
IR (infrared) handset.
Light Level Sensor
Measures the overall light level in the detection area
Status LEDs
The LED flashes Red to indicate the following:
RJ11 connector
The sensor head has a flying lead with a RJ11 plug at the
end plugs into the RJ11 socket on the power supply.
Power supply
This power supply has a 6A relay. It also has connections
for an external switch that can be used to turn on the load
when absence detection mode has been set or raised /
lowered with dimming variants.
Walk Test LED active when movement is detected
Valid setting received
Sensor head
Lens
which covers...
IR Receiver
Light Level Sensor
Status LED
Dimming version shown