CP Electronics MWS3A-PRM-2CHC, 2CHL - Manual (Page 6)

page 6
10. Programming Cont.
All the following functions can be programmed using the remote control DD-LCDHS handset. Some other
functions can be found on the DD-LCDHS handset that are not listed below - DO NOT use them if they are
not listed below, as they cannot be used with this product.
2. Modes—Switch Modes
2.1 1 position switch together A single position retractive switch controls both channels
together.
2.2. 1 position switch separate Two single position retractive switches, controlling the
channels separately. This option can only be used in
conjunction with a VITM4-2CH Vitesse Modular marshalling
box.
3. Functions (factory default in brackets):

To set Channel 1 functions - go to ―Ch1(sw) Set ― menu on the handset; or

To set Channel 2 functions - go to ―Ch2(dim) Set ― menu on the handset;
3.1 Presence detection Auto switch on with detection, auto off after movement ceases
(default) and time delay ends.
3.2 Absence detection Manual switch on, auto off after movement ceases and time delay
ends.
3.3 Switch level on (9) This is also known as ―Lux Hold Off‖. Lux level setting to
prevent the luminaires being switched on if the ambient light
level is sufficient (adjustable between 1 and 9). The luminaires
will always be switched on at level 9. For a higher resolution of ‗switch
level on‘ a scale of 101-199 is available in the ‗Special menu‘.
3.4 Switch level off (9) This is also known as ―Lux Switch Off‖. Lux level setting to switch the
luminaires off during occupancy if the ambient light level goes
above the setting (adjustable between 1 and 9). Level 9 will always
keep the lights on. This setting can be used for ―window row
switching‖. For a higher resolution of ‗switch level on‘ a scale of 101-
199 is available in the ‗Special menu‘.
Please note: If luminaires are to be switched off during occupancy due to lux, please ensure that the
―Switch level on‖ setting is lower than the ―Switch level off‖ setting.
4 User Menu
DD-LCDHS user menu or UHS handset functions:
4.1 Lux up Can only be used with the set button—see 4.6.
4.2 Lux down Can only be used with the set button—see 4.6.
4.3 Override on Permanently overrides the luminaire output on.
4.4 Override off Permanently overrides the luminaire output off.
4.5 Cancel Cancels the on or off override, returning the detector to normal operation.
4.6 Set Send before using lux up or lux down. The switch level on (see 3.3) can
then be adjusted using the lux up or lux down buttons.