CP Electronics VITMR-MWS3A-PRM - Manual (Page 4)

4
The VITMR-MWS3A-PRM is designed to be mounted using either:
 Flush fixing, or
 Surface fixing, using the optional Surface Mounting Box (part no. MWS3A-DBB).
Both methods are illustrated below.
Warning - be careful bending springs when mounting unit.
Installation
1 3 2
Hole Ø74mm
Flush fixing
Surface fixing
Head locking
1 2 3
Hole Ø30mm
MAX
1 2
Remove metal
locking clip from
rear of unit.  Adjust head to
required position.
 Push clip into position
shown below to lock
head.
 To remove clip, lever
out with a small
screwdriver.
4
If the range is compromised by the
ceiling construction / material. Add the
supplied 20mm spacer ring.