CP Electronics VITP-MWS3A - Manual

Overview
The VITP-MW3A microwave presence detector provides
automatic control of lighting loads via the VitessePlus
marshalling box.
The VITP-MW3A detects movement using a highly
sensitive microwave detector. This works by emitting low
power microwave signals and measuring the reflections as
the signals bounce off moving objects.
Functioning as a presence detector, the unit can turn lights
on when a room is occupied and off when the room is
empty. When used with a non-dimming LCM settings allow
lights to be turned off in response to ambient daylight. If a
dimming LCM is used the detector can be set-up to
implement a maintained illuminance (constant light)
system.
The VITP-MW3A has a unique adjustable sensor head that
allows the area of detection to be optimised for the
application.
All functionality is fully programmable using an IR handset.
Features
Back features
VitessePlus microwave presence detector
Product Guide
Retaining Spring
Retaining Spring
Two VitessePlus
RJ45 Connections
Microwave Sensor
Detects movement within the unit’s detection range,
allowing load control in response to changes in occupancy.
IR Receiver
Receives control and programming commands from an
IR (infrared) handset.
Light Level Sensor
Measures the overall light level in the detection area
Status LEDs
The LED flashes Red to indicate the following:
RJ45 Connections
Two RJ45 connections for CAT5 patch leads.
Walk Test LED active when movement is detected
Valid setting received
VITP-MW3A
Front features
Sensor Lens
which covers...
Microwave Sensor
IR Receiver
Light Level Sensor
Status LEDs
Mounting Bezel