CP Electronics VITM6-EBDSPIR-DD - Manual (Page 4)

4
Installation
The UNLCDHS has the ability to read back the settings stored in a device.
To read back individual parameters

Navigate to the parameter and press the ‘R’ (Read) button whilst pointing at the device. The handset will click
when the parameter has been read back, the device will flash its LED, and the value will be shown against the
parameter in the menu.
To read back all of the parameters in a menu

Press and hold the ‘R’ (Read) button for more than 1 second.
 The handset will click every time a parameter is received
 The device will show multiple flashes of its LED
 All of the values will be shown against the parameters in the menu.
 The individual parameters may be edited and then saved as a ‘Macro’.
Notes

If a parameter(s) has been missed because of a communication error, the missing value(s) is replaced by dashes.
 When reading back, the Channel 1 relay (where fitted) will temporarily be switched off, and will return to it’s normal
state 2 seconds after the read back has been completed.
Readback function (UNLCDHS handset only)
Flush Fixing
Surface Fixing
1 2 3
2 3 4 1
Hole Ø64mm
Warning - be careful
bending springs when
mounting unit.
4
Pull out spring tab and rotate
spring arm as shown
50mm or 60mm fixing centres
Important
Ensure that the cables are formed as shown
before affixing the cable clamp. The clamp
MUST clamp the outer sheath(s) only.
Bend cores as shown.
Wire stripping details
The EBDSPIR-DD is designed to be mounted using either:
 Flush fixing, or
 Surface fixing, using the optional Surface Mounting Box (part no. DBB).
Both methods are illustrated below.
Note: EBDSPIR-DD-IP & LT30 - use the supplied gasket to ensure IP rating (not compatible with Surface Mounting Box part no. DBB).