Dynex OPSYS MW 91000051 - Manual (Page 69)

Copying a Wash Protocol
Copying a Wash Protocol
An existing wash protocol can be copied to another program number. If a
wash protocol is already in that location, it will be overwritten.
To copy a wash protocol:
1. Display the main menu:
1: NAME_01
SETUP PROGRAM
2. Use the up and down scroll keys to select the wash protocol to
be modified (or enter the protocol number using the keypad). The
display will read:
4: NAME_04
SETUP PROGRAM
3. Select PROGRAM. If the wash protocol is password protected,
the display will read:
Enter password
4. Enter the Password using the keypad and press ENTER.
Note: If the Password is entered incorrectly an
error message is displayed. The operator is
allowed three attempts to enter the password.
After the third attempt, the main menu will be
displayed.
5. After a password is successfully entered, the display will read:
Edit name
4: NAME_04 COPY
6. Select COPY. The display will read:
Copy to? 7
Note: The protocol number that is displayed
represents the first free protocol number, if any
are available.
Opsys MW™ User’s Guide 61