Dynex OPSYS MW 91000051 - Manual (Page 27)

Installing the Wash Head
Installing the Wash Head
The Wash Head must be located on the Wash Head Arm.
To install the Wash Head:
1. Position the Arm over the Purge Reservoir portion of the Plate
Holder.
2. Place the Wash Head on the two Arm Pins, being careful to
properly seat the Wash Head on the support pins.
3. Level the Wash Head in relation to the Plate Holder and tighten
the two thumbscrews at the front of the Wash Head / Arm
Assembly.
Opsys MW™ User’s Guide 19